Filter
Top Products
English – 7
SETUP
Connecting the Multi-CD
Changer to your Wave
®
music system
Before you start this setup procedure, disconnect
the AC power cord on your Wave
®
music system
and set it aside. You will need to use it again in
Step 3.
1. Plug the Bose
®
link cable from the changer into the
Bose
®
link connector on your Wave
®
music system.
2. Plug the changer power cord into the AC power input
connector on the back of the Wave
®
music system.
3. Plug the AC power cord from the Wave
®
music
system into the AC power input connector on
the back of the changer.
4. Plug the other end of the AC power cord into an AC
(mains) wall outlet.
After applying power, “PLEASE WAIT” appears
on the display for about 30 seconds while the
system prepares itself for operation. DO NOT
insert any discs until this message disappears.
5. For best FM reception, straighten the AC power cord
as much as possible. Your Wave
®
music system uses
the power cord as an FM antenna.
Bose
®
link connector
AC
POWER
input
Wave
®
music system
AC power cord
Bose
®
link cable
Wave
®
music
system
Multi-CD
Changer
Changer
power
cord
For best FM reception,
straighten the power
cord as much as
possible.
1
2
3
4
5
AC POWER input
Seine_MDC_OG.book Page 7 Thursday, February 16, 2012 9:07 AM