Filter
Top Products
English – 11
OPERATION
Connecting an external
audio source
With the Multi-CD changer connected, any external
audio devices you may have used with your Wave
®
music system can be connected to the back of the
Multi-CD changer. However, you now need a dual RCA
stereo cable.
The Wave
®
music system Multi-CD Changer provides
two rear panel inputs (AUX 1 and AUX 2) for external
audio devices such as TV, VCR, DVD player, cassette
player, or MP3 player. This gives you the advantage of
hearing Wave
®
music system sound from a range of
sources.
To connect a device, connect one end of the cable to the
audio output jacks of the source and the other end to
one of the AUX inputs on the changer. Be sure to match
the red and white plugs on the cable to the red (R) and
white (L) AUX jacks on the changer.
Connection example:
Playing a connected audio
source
To listen to a connected source:
1. Turn on the external device.
2. Press AUX on the Wave
®
music system
remote control. Press AUX again to switch
between the AUX 1 and AUX 2 inputs. AUX 1
or AUX 2 appears on the display to confirm your
selection.
3. Adjust the volume using the Wave
®
music system
remote control.
Note: The Wave
®
music system remote control cannot
turn a connected AUX device on or off, or change its set-
tings or selections.
Note: Neither AUX 1 or AUX 2 can be selected as an
alarm source.
Use only a stereo connection. You will not hear
the connected device if just the left (L) or right (R)
channel is connected.
Red
Red
Dual RCA stereo cable
TV
Seine_MDC_OG.book Page 11 Thursday, February 16, 2012 9:07 AM