Filter
Top Products
14 January 4, 2002 AM189930_01_V.pdf
Clock Functions
SLEEP/SNOOZE
ON/OFF
ALARM MODE
ALARM
SET
ALARM MODE
ALARM
SET
PRESET STATIONS
ON/OFF
Simultaneously press ALARM SET and any PRESET button.
The preset indicator and the station frequency flash on the
display.
Release the ALARM SET button. Alarm 1 plays this station
until you reset the alarm.
Radio Control Operation
Press ON/OFF once. The indicators remain lit. The alarm
repeats tomorrow.
To stop
the alarm
To turn off the alarm function, press ALARM MODE until
the (
) and ( ) indicators do not appear on the display.
The alarm must be reset for next use.
To disable
Alarm 1
Hold down ALARM SET and press ALARM MODE. Alarm 2
flashes on the display. Release ALARM SET. Press ALARM
MODE until the (
) and ( ) indicators no longer appear.
To disable
Alarm 2
To wake to
your favorite
station
Press ON/OFF to silence. Backup batteries run the alarm
for approximately a week during power failure. To conserve
power, only the tone sounds, even if radio is selected. Normal
operation resumes when power is restored. Batteries should
be replaced after an extended power failure.
Alarm
operation
during a
power failure
ON/OFF
When the alarm is in tone ( ) or radio ( ) mode, press
SLEEP/SNOOZE to pause the alarm for ten minutes.
When the alarm is in tone and radio ( ) mode, press
SLEEP/SNOOZE to pause the tone and hear the radio. The
tone sounds again in ten minutes. Press again to silence the
radio. The alarm indicator flashes while paused.
To snooze
VOLUME
ON/OFF
To set the
volume of
the alarm
Simultaneously press both ALARM SET and ALARM MODE.
The display shows the wake up time for Alarm 2.
To check
Alarm 2
ALARM
SET
ALARM MODE
ALARM
SET
Press ALARM SET. The display shows the wake up time
for Alarm 1.
To check
Alarm 1
While the alarm sounds, press ON/OFF once. The alarm
stops and resets to go off at the same time tomorrow. If you
do not turn off the alarm, it continues to sound for 30
minutes. Then it stops and resets to go off at the same time
tomorrow.
To use
Auto Reset
For the radio ( ), use the VOLUME buttons to set the volume.
For tone (
), choose the alarm sound (see page 12).
Set the alarm to go off. When the alarm sounds, press either
VOLUME button to adjust the volume.
Press ON/OFF to silence the alarm. This automatically resets
the alarm to repeat tomorrow.