Filter
Top Products
English - 7
System Setup
Step 1: Place the system
A. Move your TV aside and turn it so you
can see the connection panel.
B. Place the Solo system where you had
your TV.
Placement guidelines:
• The Bose Solo system is designed to fit
under TVs that weigh no more than 40 lb
(18 kg) and have bases no wider than 20"
(508 mm) and no deeper than 10¼" (260
mm). Many 42" and most 32" TVs and
smaller meet these requirements.
• The base of your TV should be centered on the top of the system and must
not hang over any of its edges.
• If the TV base is too large to fit on top of the system, place the sound system
in another location such as on an open shelf under the TV, but keep it close to
your TV so the audio cable will reach. You also could mount your TV on the
wall above the system.
• If placing the sound system in a cabinet, or on a shelf, position the front of
the system as close as possible to the front edge of the shelf for optimum
audio performance.
Note: Placing the system in a corner, in a cabinet, or on a shelf may cause the
system audio to sound heavy or have a booming bass quality. To decrease
the bass, see “Decreasing the bass” on page 20.
CAUTIONS:
• DO NOT place a CRT type TV on this system. It is not designed for use with this
type of TV.
• Allowing the base of your TV to hang over any edge of this speaker system
increases the risk of the TV tipping, which may result in injury.
• If placing the sound system backed up to a wall, make sure there is a space of at
least 1" (2.5 cm) between the wall and the rear of the system.
• With any placement of this product, make sure the ventilation openings on the
rear panel are not blocked.
• If your TV comes with an anti-tip device, install it according to the manufacturer’s
instructions and adjust the tether as instructed after placing the TV on top of the
system. Installing an anti-tip device is recommended when using a TV with this
product. If your TV did not come with an anti-tip device, you can get one from
most retail TV suppliers.
A
B