Filter
Top Products
16 – English
SYSTEM SETUP
Step 1: Set up the remote control
A. Slide the battery compartment cover off the back of the remote control.
B. Install four AA (IEC LR6) batteries, matching the polarity markings (+ and –) to the
markings inside the battery compartment.
C. Slide the battery cover back into place.
Step 2: Turn your system on and follow the
on-screen instructions
A. Press the power button ( ) on the control console to turn on your system.
Because the system is in a low power state when in standby, it takes several
seconds to start. When the power light on the control console changes from blinking
to steady green, your system is ready to use.
B. Check that the status indicator on the speaker array is off.
AA (IEC LR6) batteries (4)
Battery compartment cover
Power
light
Status
If the Status indicator is blinking orange:
• There is no wireless connection between the speaker array and the
Acoustimass
®
module.
• See the Troubleshooting table in the back of the operating guide and
follow the instructions for correcting the problem of “No Sound.”
HersheyP_Setup.book Page 16 Thursday, March 31, 2011 11:57 AM