Filter
Top Products
9
Selecting Power Levels
The front-mounted selector switch is used to set the
appropriate power level or impedance for your system.
Using your fingers or a flat-blade screwdriver, turn the
knob until the arrow points to the power level you
require.
70V Systems
A power setting scale for 70V systems is labeled on the
switch. Six settings are available, from 2 to 64 watts.
8-ohm Systems
The fully counterclockwise position of the setting switch is the 8-ohm position. This set-
ting is suitable for use with low-impedance amplifiers that typically support 4- or 8-ohm
speakers.
Speaker Grille Installation & Removal
Installation
The speaker grille fits tightly! Push the speaker grille in
until it can go no further. Then, slap around the edge of
the grille to seat the grille. The grille is properly seated
when it is flush with the edge of the bezel.
Note: Black butyl rubber tape is included for extra security in holding the grille in
place. Cut four small pieces and space them equidistant around the groove in the baf-
fle where the grille fits. The butyl rubber tape is quite sticky and it is not necessary
to use an excessive amount.
Removal
Insert a pocketknife blade between the grille and the
bezel about 1/4" deep and then gently pry the grille
upwards. Do this in multiple places around the
circumference of the grille to free the grille.