Filter
Top Products
Using the Headset Clip Mount with Adhesive
1. Before removing the protective strip from the double-sided adhesive, find
the best location to place the Headset Clip Mount.
2. Clean the part of the helmet that the Headset Clip Mount with Adhesive will
be attached to. Remove any dirt or grease. Do not use cleaners that may
damage the helmet or that will leave an oily residue. Make sure the surface
is dry before continuing.
3. Check again the positioning of the clip. Once it is mounted it will not be
possible to move without making the
adhesive unusable. So please take care
when choosing its position.
4. Note that the small section of the two
holes/slots in the Clip must be faced
towards the bottom of the helmet. As
shown in the picture to the right.
5. Remove the protective strip from the
double-sided adhesive and carefully
attach the Clip to the outside shell of the
helmet.
Mounting the InterPhone
1. Take your InterPhone
Headset and slide it down
into the slots in the
Headset Clip Mount.
Make sure that it’s
perfectly fitted and locked
into place by trying to
extract it, pulling upwards.
2. Now you need to attach the
speaker and microphone
arm to the inside of the
helmet. Take the Velcro
pad which the speaker will
attach to, and test for the
best position to fix it. The
Velcro Pad should be fixed
at the height of your ear in the helmets ear pocket. You will need to put the
helmet on a few times to find the optimum position to apply the pad. When the
correct positioning is found, remove the protective strip and apply the Velcro
Pad.
5