Filter
Top Products
Operating Instructions l
Before operating the unit for the first item (or after reconnecting the battery, etc.) press the Reset
Button on the Commander. See page 5. Load the discs into the CD magazine and install the magazine
into the CD charger.
Turning Unit On/Playing A CD
Vehicle ignition must be on. Turn on the car stereo and select FM band. Tune the radio to either 89.1 or
88.7 MHz. (depending on frequency chosen during installation). We suggest dedicating a Preset Radio
Station Button to the frequency chosen during installation. To turn CD Changer on, press Play/Pause
Button (1).
The
LCD panel on the controller will illuminate and show the Disc Number, the Track
Number. Play of first disc
will.begin.
Pause
Press the Play/Pause Button (1) during play.
II
appears on the displayand play is temporarily stopped.
Press the button again to resume play starting from where it was stopped. When the pause mode is
maintained for 5 minutes or more, the power will be automatically turned off.
Turning Unit Off
Press the OFF Button (4) to turn the unit off. The Commander’s backlighting stays on.
At The End Of The Disc
When the last track on each disc is finished, the next available disc is automatically selected and play
begins with the first track on the disc. When the last track on the last disc in
the
CD magazine is
finished, the first disc is automatically selected and play begins with the first track on the disc.
Moving To Another Track
l
To go to the next track, press and release the
w
Control (3).
l
To go back to the beginning of the track being played, press and release the
w
Control (3).
l
Press these controls repeatedly to locate previous or succeeding tracks.
Audible Cue/Review
l
To move within a track, press and hold the
w
Control (3) for audible cue or the
H1
control (3) for
audible review.
l
The display flashes, and play is skipped to the desired part of a track in the forward or backward
direction.
l
When the Track Select Button is kept depressed until the start or end of the disc is reached, the unit
goes into a Pause mode.
Switching to Another Disc
Display the number of the disc to be heard using the Disc Select Button (2).
l
To advance to the next disc, press the right side of the Disc Select Button.
l
To return the previous disc, press the left side of the Disc Select Button.
Continued on Next Page
15