Filter
Top Products
12
1. Press button LOC 7 for at least 3
seconds until you hear a confirmation
beep (no beep if 'BEEP OFF' previously
set). The display shows the current
setting, for eg. 'SD-VOL 2'.
2. Press tuning buttons (;) within
8 seconds to select the desired setting
between 'SD-VOL 0' and 'SD-VOL 5'.
3. To store the selected setting, press
button LOC 7 again for at least 3
seconds until you hear a confirmation
beep (no beep if 'BEEP OFF' previously
set).
Display during setting for speed dependent
volume control.
If you don't store the new setting within
8 seconds after the last press of a button, it
will not be stored. To turn this feature off,
select and save 'SD-VOL 0'.
Additional Features
Speed dependent volume control
The speed dependent volume control
adjusts the volume depending on the vehicle
speed. As the vehicle increases in speed,
the volume of the radio also increases to
compensate for the associated speed
noises.
Please note:
This feature will not always compensate for
the driving noise. There are other variable
factors such as road surface, wind noise,
windows open, engine speed etc. that may
alter the interior noise for any given road
speed.
For this reason there are five different levels
of compensation available to allow you to
find the level of compensation that best suits
your average driving conditions.
You can select the compensation curves
between 0 (off) and 5 (maximum compensa-
tion) as follows:
Audio Menu Adjustment
Press the volume control > to activate and
select audio menu.
When any of the audio menu (Bass/Treble/
Fader/Balance) is on the display, you can
select the next menu by pressing the button
O E once or as many times as required.
Increase or decrease the setting by pressing
the button + C or - D.
SD-VOL 2