Filter
Top Products
Page 12
)LJXUH.
)LJXUH/
)LJXUH0
Brid
g
ed application (Hi
g
h volta
g
e)
The ST260 ma
y
be brid
g
ed to drive a hi
g
h impedance speaker. To use, place the
source
g
roup jumper for both channels on the ‘L BUS’ jumper terminal. Place the
volume
g
roup jumper for both channels on the ‘NO VOL’ jumper terminal. Place the
jumper module on the ‘-L’ terminal.
Finall
y
, connect the speakers (+) to the ri
g
ht channels (+) terminal and the speakers (-)
to the left channels (+) terminal. Input
y
our source si
g
nal into the left channel input
(
only the left channel may be used for brid
g
in
g
).
Note: The default position for this jumper plug is set to the ‘+L’ terminal. The jumper plug must be
installed at this location at all times when not using the ‘-L’ (invert) function.