Filter
Top Products
13259 0303
42
Set input source name - From the factory, your receiver will display source names that match those printed on
the rear of the receiver and on the supplied remote. However, your receiver allows you to change the displayed
names to match the actual sources used. If you do not want to change the names then skip this step. Note that
the tuner name cannot be changed.
From Remote From Front Panel Action
8
À(PAUSE) or §(STOP)
. (UP) or - (DOWN) move to Name
9 SEL or ENTER
↵ (ENTER)
activate NAME editing
10
¶(REW) or •(FF)
VOLUME KNOB move to character position
11
À(PAUSE) or §(STOP)
. (UP) or - (DOWN) change blinking character
12
¶(REW) or •(FF)
VOLUME KNOB move to new character position
13 repeat 10 - 12 repeat 10 - 12 continue changing characters
14 SEL or ENTER
↵ (ENTER)
deactivate NAME editing
Set component video - Allows you to associate one of two component video inputs with each of your input
sources. When you choose that source for viewing, the associated component video input will be routed to the
component video output COMPONENT VIDEO SWITCHING IS CURRENTLY NOT SUPPORTED IN THE
AVR202 Plus.
From Remote From Front Panel Action
15
À(PAUSE) or §(STOP)
. (UP) or - (DOWN) move to Component Video
16
¶(REW) or •(FF)
VOLUME KNOB select 1 or 2 for use with source
SETUP DVD INPUT
1 Favorite Mode Surround
2 Favorite Speakers 7
3 Level 0.0 dB
4 Name DVD
5 Component Video 2
6 DVD Audio Input No
next item adjust
MENU setup system
DVD NAME DVD
4 Name DVD
SETUP DVD INPUT
1 Favorite Mode Surround
2 Favorite Speakers 7
3 Level 0.0 dB
4 Name DVD
5 Component Video 2
6 DVD Audio Input No
SEL save name
character position
MENU setup system
DVD NAME DVD
4 Name DVD
SETUP DVD INPUT
1 Favorite Mode Surround
2 Favorite Speakers 7
3 Level 0.0 dB
4 Name DVD
5 Component Video 2
6 DVD Audio Input No
next item adjust
MENU setup system
DVD CMP VID 2
5 Component Video 2