Filter
Top Products
Edit Preset Options
This menu allows you to configure your EDIT PRESET menu (see OPERATION - PRESETS) to allow changing
only the preset title (as you are used to if you have used older B&K equipment) or a more versatile mode that
allows for directly editing common preset information from the EDIT PRESET menu. Check that you are in USER
PREFERENCE SETUP and that the remote is in AUDIO mode.
EDIT PRESET OPTIONS
Full Edit Preset No
USER PREFERENCE SETUP
1 Edit Preset Options
2 Edit Source Name
3 Display Setup
4 Surround Modes
move to new line
select menu page
previous page
↑ ↓
SEL
MENU
adjust parameter
previous page
←→
MENU
5 Memory Options
Changes allowed only
to the PRESET TITLES
return to USER PREFERENCE SETUP
MENU
MENU4
choose optionVOLUME KNOB
(REW) or
(FF)
3
activate EDIT PRESET OPTIONS
↵
(ENTER)
SEL or ENTER2
move to Edit Preset Options
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
Edit Source Name
From the factory, your receiver will display source names that match those printed on the rear of the receiver and
on the supplied remote. However, this menu allows you to change the displayed names to match the actual
sources used. If you do not want to change the names then skip this step. Note that the tuner name cannot be
changed. Check that you are in USER PREFERENCE SETUP and that the remote is in AUDIO mode.
EDIT SOURCE NAME
DEFAULT USER
USER PREFERENCE SETUP
1 Edit Preset Options
2 Edit Source Name
3 Display Setup
4 Surround Modes
move to new line
select menu page
previous page
↑ ↓
SEL
MENU
change position
previous page
←→
MENU
V1 VCR
↑ ↓
change character
AUD to select control
select source to rename
Using AV system controller
5 Memory Options
21
p/n 12699 Rev. 9812C