Filter
Top Products
9
EURORACK UB1204-PRO/UB1204FX-PRO
+ The peak meters of your EURORACK display the level
virtually independent of frequency. A recording level
of 0 dB is recommended for all signal types.
MODE (UB1204FX-PRO only)
The MODE switch determines whether the channels SOLO
switch operates as PFL (Pre Fader Listen) or as solo (Solo In
Place).
PFL
To activate the PFL function, depress the MODE switch. The
PFL function should, as a rule, be used for gain setting purposes.
The signal is sourced pre-fader and assigned to the mono PFL
bus. In the PFL setting, only the left side of the peak meter
operates. Drive the individual channels to the 0 dB mark of the
VU meter.
Solo
When the MODE switch is not depressed, the stereo solo bus
is active. Solo is short for Solo In Place. This is the customary
method for listening to an individual signal or to a group of signals.
As soon as a solo switch is pressed, all channels in the control
room (and headphones) that have not been selected are muted
thereby retaining stereo panning. The solo bus can carry the
output signals of the channel pan controls, the aux sends and
the stereo line inputs. The solo bus is, as a rule, switched post-
fader.
+ The PAN control in the channel strip offers a
constant power characteristic. This means that the
signal is always at a constant level, irrespective of
its position in the stereo panorama. If the PAN
control is moved fully left or right from center, the