Filter
Top Products
Dear Friend,
Thank you for selecting Bazooka
®
subwoofer speaker systems for your car stereo
system. The Bazooka Reference series represents SAS‘s continued commitment to
efficiency and design. An innovative manufacturing process developed by SAS for
the Bazooka provides consumers with state-of-the-art speaker system design. At
SAS, we take pride in manufacturing the most revolutionary bass speaker systems
ever created, featuring our patented Bass Tubes
®
enclosure design, and we hope
you will take pride in owning them.
Several years ago, we realized that efficiency was the wave of the future in
autosound, so we made a commitment to design, manufacture, and deliver the most
efficient speaker systems possible.
Today we market our patented speaker systems worldwide and the high quality of
the Bazooka brand is well respected by consumers and dealers of all nationalities.
When properly installed, Bazooka subwoofer speaker systems will give you
years of clean uninterrupted sound reproduction. Therefore, I urge you to take a
few minutes of your time to review this instruction booklet. It was designed to give
you a better understanding of our products and to explain how to apply them properly.
Thank you again for choosing Bazooka. Our early commitment to quality has made
them the product of choice, and I am sure you will agree that you have made the
right one! Enjoy!
Sincerely,
JON C. JORDAN
President
SAS/BAZOOKA
DESIGN &
ENGINEERING
AWARD
I
N
N
O
V
A
T
I
O
N
S
'
9
1
C
O
N
S
U
M
E
R
E
L
E
C
T
R
O
N
I
C
S
S
H
O
W
S
CONGRATULATIONS
1 14
The built-in crossover on the Amplified Bazooka is a 18 dB per octave electronic
low pass filter, it has a 60 Hz to 250 Hz variable crossover point. Select the
crossover point that you feel best fits your system design. Set the potentiometer
labeled XOVER to the point you selected, 60 Hz being all the way to the left (coun-
terclockwise) and 250 Hz being all the way to the right (clockwise). When you
have set the crossover, proceed to the next step.
ADJUSTING THE CROSSOVER
ADJUSTING LEVEL GAIN CONTROL
Locate the potentiometer labeled LEVEL. This is the level control. Start with the
level control turned all the way to the left (counterclockwise). The bass should be
off or very low at this point. Turn up your head unit until the sound from the exist-
ing speakers starts to clip or distort. This is the point in your system where you
will get maximum volume with the least amount of distortion. With the head unit
at this point, turn the level gain control up slowly until the bass volume blends
well with the existing high frequency speakers. This should be the proper setting
for the level gain control. Now that the level is set, you may want to go back to
the x-over control and adjust the x-over point by ear to meet the desired sonic
quality of your system design.