Filter
Top Products
1. Backup Agent Plug-in Installation
Procedure overview
1. Perform the plug-in installation by choosing one of two possible deployment m ethods:
- Perform the installation provided by the integrator. See "Plug-in installation provided by the integrator", page 2 .
- Perform the installation from USB media. See "Plug-in installation from US B media", page 2 .
2. Perform the “Backup Agent” setting. See "Setting of “Bac kup Agent” service", page 3 .
3. Launch the first b ackup.
It is possible that the plug-in "Backup Agent" is distributed in the same package as the TMS application
(Upgrade 5.6.3 and higher). In this case, the step 1 shouldn’t be performed. You must directly perform the
parameters setting and the initial backu p (step 2 and 3).
Particular case of the Update
It is possible to install the plug-in on a server where an earlier version of "Backup A gent" has already been deployed . In this case,
the previous configuration is kept in place. It is not necessary to perform the configuration steps but it is recommended to launch
the manual bac kups (step 3).
1.4 Plug-in installation provided by the integrator
This method requires t hat the server is connected to t he internet. The integrator must be able to send the
necessary files to install the p lug-in before starting the procedure.
How t o pe rform the installation provided by the integrator.
1. Make sure with your integrator that the installation package was remotely pushed on the s erver..
2. Press the exit button in the TMS application.
3. Whe n the Logout panel appears, push on the “Update” button. T he button is active when an update is available on the machine.
Note: If the "update" button is not active, it means that the installation files are not yet present on the server. You must restart
the complete proce dure once the files are transferred. Check with your integrator
4. The TMS application stops.
5. The installation procedure runs autom atically. This installation may take several minutes.
6. After the installation, the server and the TMS application restart automatically. If this is not the case, restart the server manually
by pressing the “reset” button on the front panel.
Note: The installation file and its security key fi le are automatically removed from the usual update folder.
1.5 Plug-in installation from USB media
Necessary part
• USB m edia with the plug- in installation file and its security key file in root directory. Any other locations on the USB media w ill
not be detected by the server. The USB media is not supplied by Barco.
How to perform the installation from USB media
1. Connect a USB media with the plug-in installation file and its security key file to the server.
2. Wait a few seconds and press the exit button in the TMS application.
3. Whe n the Logout panel appears, push on the “Update” button. T he button is active when an update is available on the machine.
Note: If the "update" button is not active, it means that th
e installation files are not present on the US B media or the USB m edia
is not c orrectly connected to the server. You must restart the complete procedure once the installation files are correctly
placed on a well c onnected USB media.
4. The TMS application stops.
5. The installation procedure runs autom atically. This installation may take several minutes.
6. After the installation, the server and the TMS application restart automatically. If this is not the case, restart the server manually
by pressing the “reset” button on the front panel.
7. Disconnect the US B media to not interfere with any other future update.
2
R59770810 BACKUP AGENT PLUG-IN 06/11/2012