Azden IRH15C Headphones User Manual


 
2
Page Subject
2 Important Safety Instructions
3 Handling care for Ni-MH battery
4 Introduction
5 Feature
6 System configuration, Installation case beside Plasma Display Monitor
7 IRR-30 Receiver set up
8 IRR-15 Receiver set up
9 IRB-10c Transmitter
10 IRN-10 Transmitter
11 IRH-15c Handheld Microphone
12 IRD-10/20/60 External Sensor
13 Trouble shooting
13 Microphone suggestions, Regulation
14 Specification
Index
15
Specification
Sub-carrier Frequency
Type
Modulation
S/N Ratio
Reception Sensitivity
Audio Output Adjustment
Audio Output Impedance
Power Requirement
Size
Weight
2.06MHz&2.56MHzIRR-15: 1CH IRR-30:2CH
Super Heterodyne-Crystal Controlled
FM
More than 90dB
More than 25dBV
Mic:-20dB maxLine: 0dB max
Mic:Less than 1.5kLine: Less than 1k
12V DC 350mA
100(W) x 161(D) x 44(H)mm (IRR-15)
215(W) x 210(D) x 44(H)mm (IRR-30)
530g (IRR-15)
1.15kg(IRR-30)
IRR-15/IRR-30 Receiver
Sub-carrier Frequency
Modulation
Microphone Element Type
Battery Type
Battery Life
Size
Weight
2.06MHz&2.56MHz Switchable
FM
Uni Directional Dynamic
2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
>8hours w/alkaline batteries -low power mode
>5hours w/alkaline batteries -high power mode
240 x 58mm
300g w/alkaline batteries
IRH-15c
Sub-carrier Frequency
Modulation
Microphone Element Type
Frequency Response
Battery Type
Battery Life
Size
Weight
2.06MHz&2.56MHz Switchable
FM
Electret Condenser
50-10kHz 3dB
2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
>10hours w/alkaline batteries -low power mode
>8hours w/alkaline batteries -high power mode
100(H) x 64(W) x 27(D)mm
140g w/alkalaine batteries
IRB-10c
Output
Power
Size
Weight
F-Connector(IRD-30/60) / RCA-Connector(IRD-10)
Powered by reciever (24V 10mA)
52(W)x27(H)x73(D)mm (IRD-10)
72.5(W)27(H)50(D)mm (IRD-30)
10030mm (IRD-60)
210g Included 10m cable and bracket(IRD-10)
90g Included mounting bracket (IRD-30)
170g Include mounting bracket (IRD-60)
IRD-10/30/IRD-60
Sub-carrier frequencies
Modulation
Microphone element type
Frequency response
Ext Mic Input Jack
Battery type
Battery life
Size
Weight
2.06MHz or 2.56MHz
FM
Uni-directional electret x 2
50-9kHz 3dB
3.5mm
2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargeable Ni-MH or Ni-Cd(1.2 x 2)
>10hours w/alkaline batteries- low power mode
>8hours w/alkaline batteries- high power mode
80(H)x70(W)x27(D)mm
120g- Transmitter w/alkaline batteries
62g Transmitter w/o alkaline batteries
IRN-10
Important Safety Instructions
1. Read these instructions for use.
2. Keep these instructions in a safe place.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as central heating radiators, electric heaters, stoves,
or other units that produce heat (e.g. amplifiers).
9.Only use attachments/accessories specified by the manufacturer.
10.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the unit. When a cart is used, use caution when moving the cart/unit combination to avoid injury
from tip-over.
11.Unplug during lightning storms or when unused for long periods of time.
12.Refer all servicing to qualified service personnel. Servicing is required if the unit has been
damaged in any way, such as mains cable or plug damage, liquid has been spilled, objects have
fallen inside, the unit has been exposed to rain or moisture, does not operate properly or has
been dropped.