Filter
Top Products
Command Functions
The C-5xe may either be controlled by the remote
control handset via a receiver on the front panel or
by a system controller via the control port. A small
toggle switch on the rear panel selects which mode
is active.
For normal use, set this switch to “IR Receiver”.
Set the switch to “Control Port” only when using
a custom programmed system controller.
Command files are available from the Ayre factory
in both Crestron and Pronto (CCF) format. These
files include discrete on/off commands.
Power Status Information
The control port will also transmit the current
power status (”Operate” or “Standby”) of the C-5xe
information to a system controller. This feedback
ensures that system controller remains synchronized
with the actual state of the unit.
30