Filter
Top Products
19
5. Carefully lift each upper speaker cabinet by the small overhang at the
base, and place it directly on top of the lower speaker cabinet, with the set-
up blocks between them. Then gently slide the upper cabinet slightly forward
to expose the wiring tubes in the lower cabinet (See Figure 3.4).
6. Route the upper speaker cabinet wiring through the wiring tubes and out
the bottom rear of the lower speaker cabinets, as shown in Figure 3.4.
6. Once the wiring is routed through the wiring tubes, slide the upper speakers
cabinets back, so that the couplers on the upper speaker cabinet are directly
above the sockets on the lower speaker cabinet (see Figure 3.5). If
necessary, gently adjust the upper speaker cabinet on the set-up blocks.
7. Remove the set-up blocks (refer to Figure 3.5): Lift the back side of the
upper speaker cabinet slightly, freeing the rear set-up block. Remove the
rear set-up block, and carefully lower the two rear Apex
‘
Couplers into their
respective receiving sockets. Then lift the front side of the upper speaker
Figure 3.4 – Placement of upper speaker cabinet atop lower speaker cabinet.
The upper speaker cabinet is slid forward to allow for routing of the upper
speaker cabinet wiring through the wiring tubes.