Filter
Top Products
17
3.1 Lower Speaker Cabinet Set-up
CAUTION: Three people are required for the set-up procedure. To avoid injury,
do NOT attempt to set-up by oneself.
1. Carefully lift and place each lower speaker cabinet in its measured final
location, as it becomes more difficult to move once the Apex
‘
couplers are
attached. Carefully route the sub's integral wiring between the legs of the
cabinet base, thereby protecting the wiring harnesses from becoming
pinched.
WARNING: The wiring harnesses are fragile and can be easily damaged by
pinching them beneath the cabinet base.
2. Lay the speaker on its side, using a blanket or other soft material to avoid
scratching the finish.
3. Install three Apex
‘
couplers on the bottom of the cabinet by fastening the
threaded ends of the couplers into the cabinet inserts (see Figure 3.2). Lightly
tighten the couplers and insure that the base of the coupler contacts the
bottom of the recess.
4. Stand up the cabinet, again carefully routing the wiring harness to prevent
it from becoming pinched.
5. Measure and adjust the location of the cabinet within the listening room.
The cabinet should be set in place with a minimum of toe-in (no more than
two or three degrees).
Coupler seated
on bottom of
recess
Figure 3.2 – Installation of Apex
‘
couplers.