Filter
Top Products
11
3 Wiring Instructions
Introduction
The crossover is housed in a sealed, non-accessible chamber in the bottom of the speaker
cabinet, to minimize the effect of vibration on the components. The Opus Ceramic is
equipped with high-quality barrier terminals for connecting the speaker cables. Ring terminals
or spade lugs designed for #10 screws are recommended for cable termination.
Connecting the Speaker to the Amplifier
1. Place the speaker in its approximate location, then lay the speaker on its side, using a soft
surface to avoid scratching the finish.
2. Connect the speaker wires to the terminal block on the speaker bottom (see Figure 3.1).
Check to insure the correct polarity (positive lead connected to the (+) terminal and negative
lead connected to the (-) terminal.
Do NOT over-tighten the screws.
3. Stand the speakers up.