Filter
Top Products
CD CHANGER CONTROLS
Built into this radio are controls to operate an optional 10-disc or 6-disc CD changer. Please
check with your SPS/Audiovox or Prestige car stereo specialist for recommendations of the
models that will work with this radio.
Adjustments of the audio functions (volume, tone, balance, and fader) operate in the same
manner during CD play as they do for radio/cassette play. The following controls will operate
the CD changer when it is installed and connected to this radio. Refer to the owner’s manual
included with the CD changer for instructions on the installation and correct loading and use
of the CD magazine.
cm MODESELECTOR(MODE)
With the CD changer connected to the unit, this button is used to select CD changer
operation. To choose CD mode, press the button until the “DISC” and “TRACK” indications
appear on the display panel. Press the Mode button again to change back to radio or tape
operation.
cn & co DISC SELECT ( DISC ) ( DISC )
These buttons are used to select the desired disc for play. To advance to a higher number
disc, press the “DISC “ button
cn . To return to a lower number disc, press the
“ DISC” button co. The number of the disc in play will be shown on the display panel.
cp TRACK SELECT ( TRACK )
This button is used to quickly select the beginning of a particular track. Tap the Forward Track
Select ( ) side of the button or Backward Track Select ( ) side of the button to locate
the desired track as shown by the track number on the display panel.
cq CUE/REVIEW FUNCTIONS ( ) ( )
High-speed audible search to any section of the disc can be made by the Cue and Review
functions. Press and hold the Cue ( ) side of the button to advance rapidly in forward
direction or the Review ( ) side of the button to advance rapidly in the backward direction.
When the Cue ( ) side of the button is held down and the end of the last track on the
disc is reached or the Review ( ) side of the button is held down until the beginning of
the first track is reached, the unit will enter the Pause mode ( will flash on the display
panel) until the button is released.
cr PAUSESELECTOR
Pressing this button will temporarily stop play of the disc (the indication will flash on the
display panel). Press the button again to resume play of the disc from the point at which it
had stopped.
cs TRACK/DISCSCAN(SCAN)
When the Scan button
cs is pressed, the “SCAN” indication will appear on the display panel
and the first 10 seconds of each track on the disc will be played in order. When a desired
track is reached, press the Scan button cs again and play of that track will continue (“SCAN”
will disappear from the display panel). The Track Scan mode will also be cancelled by
activating any other disc function (Select, Cue, Review, Shuffle or Repeat).
When the Scan button
cs is pressed and held longer than 2 seconds, the “DISC” and “SCAN”
indications will appear on the display panel and the first 10 seconds of the first track on each
disc will be played. When a desired disc is reached, press the Scan button cs again and
-5-