Filter
Top Products
128-6105
4 of 6
4
After the desired channel is programmed, turn the ignition key to the off
position to exit programming mode.
VALET SWITCH
Press and Release 3 Times
Press and Release 4 Times
Press and Release 5 Times
Press and Release 6 Times
LED
1 Flash
2 Flashes
3 Flashes
4 Flashes
10. Press and release the valet/override switch one time to advance to
channel 4 if so equipped. If your system does not have a 4th channel,
a long chirp followed by a short chirp tone will indicate that the
program mode has been exited.
11. The dash mounted LED will flash 4 times and siren will "chirp" 4 times
indicating that the system is ready to accept programming of channel 4.
12. (a)Press and hold any combination of two buttons simultaneously, until
the siren emits a long chirp tone. This confirms that programming of
channel 4 was successful. Up to 4 transmitters can be programmed,
press and hold the selected button of each additional transmitter until
the chirp tone is heard.
(b)Press and hold the remaining Opt. button of the transmitter until the
siren emits a long chirp tone. This confirms that programming of
channel 4 was successful. Up to 4 transmitters can be programmed,
press and hold the selected button of each additional transmitter until
the chirp tone is heard.
or press and release the push button switch to exit the programming
mode,
or turn the ignition switch off to exit the programming mode.
The siren emits a long followed by a short chirp tone indicating that the
program mode has been exited.
NOTE: If programming to a Keyless Entry (non alarm) unit, there will be
NO chirp indication.
QUICK REFERENCE:
You can program any individual channel, without reprogramming all
channels, by following the quick reference chart below. (Not All Units Have
4 Channels)
CHANNEL
1
2
3
4