Filter
Top Products
128-6105
3 of 6
3
The chirp tone confirms that programming of channel 1 was successful.
Up to 4 transmitters can be programmed, press and hold the selected
button of each additional transmitter until the chirp tone is heard, or
move to step #5
(b) You can assign the Lock/Unlock, Arm/Disarm button, by pressing
and holding the lock/unlock button until the siren emits a long chirp
tone.
The chirp tone confirms that programming of channel 1 was
successful. Up to 4 transmitters can be programmed, press and hold
the selected button of each additional transmitter until the chirp tone
is heard, or press and release the valet pushbutton switch two times
to advance to step #8.
5. Press and release the valet/override switch one time to advance to
channel 2.
6. (a) The dash mounted LED will flash 2 times, and the siren will "chirp"
2 times indicating that the system is ready to accept programming for
channel 2. Unlock/2nd Unlock, Disarm, and Panic. Press and hold
the Unlock button on your keychain transmitter until the siren emits
a long chirp tone. This confirms that programming of channel 2
was successful. Up to 4 transmitters can be programmed, press
and hold the selected button of each additional transmitter until the
chirp tone is heard.
(b) Press and release the valet/override switch 1 time then move onto
step #7 or.
7. Press and release the valet/override switch one time to advance to
channel 3.
8. The dash mounted LED will flash 3 times, and the siren will "chirp"
3 times, indicating that the system is ready to accept programming
for channel 3. Trunk Release Output, (where so equipped), or
alternate channel output when used.
9. (a) Press and hold the Opt. button on your keychain transmitter until the
siren emits a long chirp tone. This confirms that programming of
channel 3 was successful. Up to 4 transmitters can be programmed,
press and hold the selected button of each additional transmitter until
the chirp tone is heard.
(b) Press and hold the 1st Opt. button on your keychain transmitter until
the siren emits a long chirp tone. This confirms that programming of
channel 3 was successful. Up to 4 transmitters can be programmed,
press and hold the selected button of each additional transmitter until
the chirp tone is heard.