Filter
Top Products
128-6105
2 of 6
2
PROGRAMMING TRANSMITTERS:
It is important to remember that during programming, each individual step of
the procedure must be executed within 15 seconds of the previous step.
When the 15 second time limit is allowed to expire, the system will
automatically exit program mode. This is indicated by a long "chirp" from the
siren.
Additionally, any time the ignition key is turned off while programming, the
system will immediately exit program mode. This is also indicated by a long
"chirp" from the siren.
These steps must be initiated within 15 seconds of the ignition switch being
turned on.
TO PROGRAM ADDITIONAL TRANSMITTERS:
Note: The programming information described below assumes that the
default transmitter is being used and the Lock & Unlock icons are on separate
buttons. If you have the optional transmitter with the Lock/Unlock icon on
the same button, use letter "B" reference below for programming, (B
programming not available on all models),
Also, where indicated that the siren will emit a long chirp tone, the optional
horn may be connected instead of or along with the siren in which case
either or both the horn and siren may sound.
If the system you have is a keyless entry unit and not an alarm, there may
be no sounding device.
For units with a toggle switch instead of a pushbutton switch, where
indicated to press and release the pushbutton, instead move the toggle
switch on then off.
1. (a) Enter the vehicle and turn the ignition key to the "on" position.
(b) Enter the vehicle and turn the ignition key to the "on" position.
2. (a) Press and release the valet/bypass push button switch 3 times.
(b) Press and release the valet/bypass push button switch 3 times.
3. (a) The dash LED will flash one time, and the siren will "chirp" 1 time
indicating the system is ready to accept programming for channel 1,
Arm/Lock and Panic.
(b) The dash LED will flash one time and the siren will "chirp" 1 time
indicating the system is ready to accept programming for channel 1,
Arm/Disarm, Lock/Unlock and Panic.
4. (a) You can assign the Lock/Arm button by pressing and holding the lock
button until the siren emits a long chirp tone.