Filter
Top Products
128-5504128-5504
128-5504128-5504
128-5504
10 of 1210 of 12
10 of 1210 of 12
10 of 12
99
99
9
SPECIFICATIONS / CARE AND MAINTENANCESPECIFICATIONS / CARE AND MAINTENANCE
SPECIFICATIONS / CARE AND MAINTENANCESPECIFICATIONS / CARE AND MAINTENANCE
SPECIFICATIONS / CARE AND MAINTENANCE
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS / CARE AND MAINTENANCESPECIFICATIONS / CARE AND MAINTENANCE
SPECIFICATIONS / CARE AND MAINTENANCESPECIFICATIONS / CARE AND MAINTENANCE
SPECIFICATIONS / CARE AND MAINTENANCE
99
99
9
CARE AND MAINTENANCECARE AND MAINTENANCE
CARE AND MAINTENANCECARE AND MAINTENANCE
CARE AND MAINTENANCE
The radio portion of your new sound system does not require any maintenance. We recommend you keep
this manual for future reference on how to set the clock and for general reference of the many features found
in this unit.
As with any cassette player, the cassette section of this sound system does require a minimum of
maintenance to keep it in good working condition. The following simple care and maintenance suggestions
should be followed to prevent malfunctions of the cassette system.
Cassette Care:Cassette Care:
Cassette Care:Cassette Care:
Cassette Care:
1. Purchase a cassette cleaning kit from your local retail store. Use it! At least every 20 to 30 hours
of operation you must clean the cassette mechanism. A dirty cassette player will have a poor sound.
2. Do not use cassettes that exceed 45 minutes of play on each side.
3. Do not insert a cassette that appears to be broken, twisted or dirty or with loose or torn labels on it.
4. Always keep your cassettes away from direct sunlight or exposure to sub-freezing conditions. If a
cassette is cold, allow it to warm up before use.
5. Do not keep a cassette in the player when not in use.
6. Before inserting a cassette in the player, check that the
tape is tightly wound on the reels. Take up any excess
slack using a pencil to turn the drive hub in the cassette
(see diagram).
Size: 7" W x 2" H x 6" D
178 mm x 50 mm x 150 mm
Operating Voltage: 12 volts DC, negative ground
Output Power: 100 watts maximum (25 watts x 4 channels)
Output Wiring: Floating-ground type designed for 4 speaker use.
The amplifiers in this unit are
NOTNOT
NOTNOT
N O T designed for use with 2 speakers.
RCA pre-amp level outputs.
Output Impedance: Compatible with 4 - 8 ohm speakers
Pre-Amp Output: 500 mv.
Tuning Range: AM: 530 - 1,710 KHz. (10 KHz. step)
FM: 87.5 - 107.9 MHz. (200 KHz. step)
Sensitivity: A M : 20 uv.
F M : 1.5 uv.
FM Stereo Separation: 30 dB
Tape Frequency Response: 50-10,000 Hz.
Tape S/N Ratio: 50 dB
Wow & Flutter: 0.15% WRMS
*Specifications are subject to change without notice.