Filter
Top Products
9 AUDIO SETTING MEMORIES (P1/P2/P3)
Three pre-set buttons are provided on this unit to store
desired audio level positions into memories which
can be easily recalled. To set any of the 3 audio
memories, use the following procedure:
1. Use the Select button
3 and Level control 2 to
adjust the setting of the volume, treble, bass, bal-
ance and fader to the desired positions.
2. Press the Select button
3 to call any of the audio
functions on the display. Within 2 seconds of
pressing the Select button and while the audio
function is still on the display panel, press the pre-
set button (1 through 3) to be set and continue to
hold it in. After approximately 2 seconds, the vol-
ume will be momentarily muted and the pre-set
number will appear on the display panel indicat-
ing that the audio levels are now set into that
memory position. The settings can be recalled at
any time by pressing the Select button
3 and
then that pre-set button within 2 seconds.
bl AUDIO MUTE (MUTE)
This button is used to mute the volume from the sys-
tem. By pressing the button, the indication "MUTE"
will appear on the display panel and the volume will
be muted. Pressing the Mute button again or acti-
vating the Volume Control 2 or Select button 3 will
return the volume level to the setting in use before
the Mute function was activated.
bmAM/FM BAND SELECT OR (BND)
During radio operation, each momentary press of this
button will change the radio band. The indication
“AM1”, “AM2”, “FM1”, “FM2”, or “FM3” will appear on
the display panel according to your selection.
During disc play, pressing this button will stop play of
the disc and switch to radio operation without eject-
ing the disc. During this time, the indication will
remain on the display panel to show that a disc is
still loaded in the unit. Press the CD Mode Selector
bu to return to disc play from the beginning of the
last track in play.
bn MANUAL UP/DOWN TUNING ( / )
AUTOMATIC SEEK TUNING
Each time the button is tapped, the radio will tune
one frequency step higher. Similarly, each tap of the
button will tune one frequency step lower. To
manually tune in a station, tap the button of the ap-
propriate direction until the desired frequency is
reached.
Pressing either button for longer than 0.5 seconds
and then releasing will activate the Automatic Seek
66
66
6
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
5 BASS CONTROL
To adjust the bass level, first select the Bass mode
by pressing the Select button 3 so that the “BAS”
indication appears on the display panel. Within 5
seconds of choosing the Bass mode, press the or
button of the Level Control 2 to adjust the
bass response as desired. The bass level will be
shown on the display panel from a minimum of -7 to
a maximum of +7 (0 is flat response). The display
will automatically return to the normal indication 5
seconds after the last adjustment or when another
function is activated.
6 LEFT/RIGHT BALANCE CONTROL
To adjust the left-right speaker balance, first select
the Balance mode by pressing the Select button 3
so that the “BAL” indication appears on the display
panel. Within 5 seconds of choosing the Balance
mode, press the or button of the Level Control
2 to adjust the balance as desired. The balance
position will be shown on the display panel from
“BAL.L 15” (full left) through “BAL.R 15” (full right).
When the volume level between the left and right
speakers is equal, “BAL 0” will be shown on the
display panel. The display will automatically return
to the normal indication 5 seconds after the last ad-
justment or when another function is activated.
7 FRONT/REAR FADER CONTROL
To adjust the front-rear speaker balance, first se-
lect the Fader mode by pressing the Select button
3 so that the “FAD” indication appears on the dis-
play panel. Within 5 seconds of choosing the Fader
mode, press the or button of the Level Control
2 to adjust the front-rear speaker balance as de-
sired. The fader position will be shown on the dis-
play panel from “FAD.R 15” (full rear) through “FAD.F
15” (full front). When the level between the front
and rear speakers is equal, “FAD 0” will be shown
on the display panel. The display will automatically
return to the normal indication 5 seconds after the
last adjustment or when another function is acti-
vated.
8 LOUDNESS CONTOUR (LOUD)
When listening to music at low volume levels, this
feature will boost the bass and treble ranges to com-
pensate for the characteristics of human hearing.
Press the button to activate this feature and the in-
dication “LD” will appear on the display panel. Press-
ing the button again will deactivate the feature (the
“LD” indication will disappear from the display panel).