Filter
Top Products
FREQUENCY STEP SWITCHFREQUENCY STEP SWITCH
FREQUENCY STEP SWITCHFREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel
spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require different channel
spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/100 KHz. FM channel spacing.
Slide the switch to the appropriate position using a small screwdriver blade. The Re-Set button
cr on the
front of the chassis must then be pressed to activate the change of channel spacing.
If the suggested measures do not solve the problem, contact an approved warranty station near you for
further assistance.
ERROR CODESERROR CODES
ERROR CODESERROR CODES
ERROR CODES
If a problem should develop while operating the CD player, the following error codes may be displayed on the
LCD panel.
ERROR CODES / SPECIFICATIONS / FREQUENCY STEP SWITCHERROR CODES / SPECIFICATIONS / FREQUENCY STEP SWITCH
ERROR CODES / SPECIFICATIONS / FREQUENCY STEP SWITCHERROR CODES / SPECIFICATIONS / FREQUENCY STEP SWITCH
ERROR CODES / SPECIFICATIONS / FREQUENCY STEP SWITCH
1010
1010
10
Indicates a mechanism error or that the disc is not loading or ejecting properly. Try re-
loading or pressing the Eject button again.
Indicates an error in the microprocessor control of the CD player. Eject the disc, make sure
it is clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for
proper operation or try another disc. You may also try activating the Re-Set button
cr on the
unit, but this will also erase the time and pre-set memories.
Indicates excessive temperature conditions. CD play will resume when the temperature
returns to the normal range.
ER-1:
ER-2:
ER-3:
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
7" W x 2" H x 6-3/8" D
178 mm x 50 mm x 163 mm
12 volts DC, negative ground
120 watts maximum
( 30 watts x 4 channels)
Floating-ground type designed for 4 speaker use.
Front and rear channels CANNOT be combined (bridged)
for use with 2 speakers.
RCA low-level outputs (rear channels).
Compatible with 4-8 ohm speakers.
2.0 volts (2,000 mv.)
AM: 530-1,720 KHz. (10 KHz. step)
522-1,620 KHz. (9 KHz. step)
FM: 87.5-107.9 MHz. (200 KHz. step)
87.5-108.0 MHz. (100 KHz. step)
AM: 20 uv.
FM: 1.5 uv.
30 dB
20-20,000 Hz. ±1 dB
70 dB
60 dB
0.2%
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Low-Level Output:
Tuning Range:
Sensitivity:
FM Stereo Separation:
CD Frequency Response:
CD Signal/Noise Ratio:
CD Channel Separation:
CD Distortion:
*Specifications are subject to change without notice.