32
PACKING LIST
Main Unit
Installation Parts
Other Accessories
The mechanism in the CD changer is "locked" into place during
shipment by three transport lock screws. Be sure to remove the
screws prior to installation.
CAUTION:
After removing the transport lock screws, place the
supplied seals (A) over the screw holes. These
seals are used to keep dust out of the unit, which
could cause a malfunction.
1. To prevent a short-circuit,
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
Connect power wires last.
NOTE: If the changer is to be installed in a vehicle that is equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is disconnected,
5 the computer memory may be lost. Under these conditions, use extra caution during
installation not to cause a short circuit.
2. Do not install the unit in the following locations.
Locations exposed to direct sunlight.
Where hot air is discharged from the car heater.
In areas subject to extreme temperatures.
3. Incorrect installation can cause the disc to skip when playing.
Be sure to mount the unit firmly in place, using the supplied brackets and screws.
4 . Be sure to use the supplied screws.
Be careful not to snag any wires when tightening screws.
Be careful not to damage the vehicle wiring.
5. This unit cannot be installed on its side, end, or upside down.
Installation in such positions will cause malfunctioning of the mechanism.
BEFORE INSTALLING THE UNIT
lnstallation and Wiring Precautions
Transport Lock Screws
1pc.
1pc. 4pcs.
2pcs.
1pc.
4pcs. 1pc.
1pc.
1pc.
1pc.
1pc.
Bracket(L) Bracket(R) Hexagonal bolt
with washer (M5 x 10)
Screw (C) phillips
Head Self-Tapping Screw
(T3 x12)
5Meter Din Cable
CD Magazine(P/N 10CD56M)
lndex label sheet
Owner’s Manual
and lnstallation Guide
Self-tapping screw
(T5 x12)
Seals(A) Seals(B)
B O T T O M
F R O N T
R E A R
TRANSPORT LOCK SCREWS
(2 RIGHT SIDE,1 LEFT SIDE)
OWNER’S MANUAL
AND
INSTALLATION GUIDE
10-DISC CD CHANGER
ACC56M