Filter
Top Products
7
PROCEDURE FOR VERTICAL INSTALLATION
NOTE:
If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 6), start with step 2.
Hexagonal bolt
with washer base (M5 x10)
Bracket (R)
Bracket (L)
4
2
Attach bracket (L) and bracket (R) to each side of the unit,
using the hexagonal bolts with washer base (M5 x 10).
Mount the unit in place, using four self-tapping screws
(T5 x 12).
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Set the 4 anti-vibration springs to position "V".
Determine the mounting location, and drill four mounting
holes.
3
1
Never mount the unit near the fuel tank.
Drill holes 4 mm in diameter.
position "V"
Self-tapping screw
(T5 x 12)
Bracket (R)
Bracket (L)
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.