Filter
Top Products
CONTROLS
LCD Display
Track/Disc Scan (SCN)
Track/Disc Repeat (RPT)
Track/Disc Shuffle (SFL)
Reset Button
Play/Pause ( / II)
Power Off Switch (OFF)
Track (TRK) Select ( )
Track (TRK) Search ( )
Disc Select ( +/- )
PREPARING FOR OPERATION
1. Load CD magazine bm and insert into changer as
described on page 16.
2. Turn on your car ignition and your car stereo bn and
select “FM” band bo.
3. Tune to 89.1 on the FM band bp unless you set the
selection switch on the FM module to 88.7; then
tune to 88.7 on the FM band.
NOTE: You may find that it will be easier to use
one of your presets specifically for CD
operation.
4. Press the Reset button bq on the remotecontrol
using a pencil tip or other thin pointed instrument.
NOTE: This is only required the First Time you
use the Changer.
5. Turn on the CD changer by pressing the Play/Pause
button br. The LCD panel bs will illuminate and disc
number 1 will begin play.
6. Adjust your car radio’s volume, balance and tone
controls for desired sound.
7. When the last track on disc 1 has played, the unit
will automatically advance to the next disc in
sequence and begin playing. This will continue
until all discs have been played at which time the
unit will begin playing disc number 1 again.
13
REMOTE CONTROL OPERATING INSTRUCTIONS
Upon inserting a loaded CD magazine into the changer, the unit will begin automatically checking the magazine for the number
of discs loaded and their locations. This will occur even if the vehicle’s ignition is turned off. This process will take approximately
45 seconds. During this time, the remote control function will be inoperative.
10
2
1
3
5
4
6
7
8
9
INTRO SCAN
SHUFFLE
SHFL
REPEAT
OFF
12
13
14
11
FM 89.1
2
4
8
3
6
5
10
1
9 7
17
16
15