10
WIRING THE FM MODULATOR
The FM modulator should be positioned near your existing
car stereo and the 15 foot data cable should be connected to it.
Make the following connections to the FM modulator:
DATA CABLE
The 15 foot data cable connects the changer to the FM module.
First connect the end of the data cable labelled "TO CD
CHANGER" to the 8-pin socket on the left side of the changer.
Route the other end of the cable up to the car’s dashboard area
near your existing car radio and plug the data cable into the 8-
pin mating socket on the end of the FM modulator.
WIRING THE CD CHANGER
ORANGE WITH WHITE STRIPE WIRE
Attached to the FM modulator is a 3-foot ACC Power wire
(orange with white stripe). This is to be connected to a + 12
volt circuit that is only live when the ignition is on. The best
connection point is at the car’s fuse block at the “RADIO” or
“ACCESSORY” identified terminals.
GREEN WITH WHITE STRIPE POWER
WIRE
The 3 foot +12 Constant Power wire (green with white stripe)
must be connected to a live 12 volt wire in the vehicle. You
will have to check the wire you connect it to and make
certain it is always live, even when the car’s ignition is turned
off. If none is found, route the wire to the car’s fuse block
and connect it to a live circuit there.
15 FOOT DATA CABLE
"TO CD CHANGER"
LABEL
CAR FUSE BLOCK
ORANGE w/WHITE
STRIPE WIRE
15 FOOT EXTENSION LEAD
(MAY NOT BE REQUIRED)
SPLICE INTO "LIVE" WIRE
AND TAPE SPLICE
EXISTING +12
VOLT "LIVE" WIRE
"RADIO" OR "ACCESSORY"
TERMINAL
FM MODULATOR
12 VOLT
CAR BATTERY
FM MODULATOR
FM MODULATOR
GREEN w/WHITE
STRIPE WIRE
FILTER BOX
5 AMP FUSE