Filter
Top Products
HEX NUT
PERFORATED STRAP
SCREW STUD
RADIO
EXISTING DASH TRIMPANEL
SCREW
SHAFT NUT
HEX NUT
MOUNTING PLATE FROM KIT
(NOT INCLUDED WITH RADIO)
HELP!
Monday - Friday
Saturday
8:30am - 7:00pm Eastern
9:00am - 5:00pm Eastern
-7-
IMPORTANT
A MOUNTING KIT IS
REQUIRED
FOR THIS INSTALLATION
CHRCHR
CHRCHR
CHR
YY
YY
Y
SLER-DODGE-PLSLER-DODGE-PL
SLER-DODGE-PLSLER-DODGE-PL
SLER-DODGE-PL
YY
YY
Y
MOUTH INSTMOUTH INST
MOUTH INSTMOUTH INST
MOUTH INST
ALLALL
ALLALL
ALL
AA
AA
A
TT
TT
T
IONION
IONION
ION
ALL U.S. MAALL U.S. MA
ALL U.S. MAALL U.S. MA
ALL U.S. MA
DE CADE CA
DE CADE CA
DE CA
RS, TRUCKS, ARS, TRUCKS, A
RS, TRUCKS, ARS, TRUCKS, A
RS, TRUCKS, A
ND VAND VA
ND VAND VA
ND VA
NS BUILNS BUIL
NS BUILNS BUIL
NS BUIL
T SINCE T SINCE
T SINCE T SINCE
T SINCE
19741974
19741974
1974
Important-This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth vehicle without an
installation kit. Refer to the Kit Listing on Page 1 for the required kit. Complete kit installation is explained in the
instructions included with the kit.
1. Remove the Existing Radio:1. Remove the Existing Radio:
1. Remove the Existing Radio:1. Remove the Existing Radio:
1. Remove the Existing Radio:
A. Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured
by screws and/or snap-in clips.
B. Remove the two large screws used to secure radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Install the New Radio:2. Install the New Radio:
2. Install the New Radio:2. Install the New Radio:
2. Install the New Radio:
A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied
with the kit.
B. Place the radio near the dashboard so the wires can be led through the opening and following the
instructions of Step 2 on Page 2 and the diagram on Page 8, carefully wire the radio making certain all
connections are secure and insulated and confirm proper operation.
C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or
below the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from
the weight of the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.
1-800-645-49941-800-645-4994
1-800-645-49941-800-645-4994
1-800-645-4994