Filter
Top Products
PERFORATED STRAP
HEX NUT
SCREW STUD
RADIO
NOSE PIECE COLLAR
(INCLUDED WITH RADIO)
SHAFT NUTS
DASHBOARD
METAL PART OF DASHBOARD
DRILL HOLE IF
NECESSARY
HEX NUT
SCREW
FORD-LINCOLN-MERCURFORD-LINCOLN-MERCUR
FORD-LINCOLN-MERCURFORD-LINCOLN-MERCUR
FORD-LINCOLN-MERCUR
Y INSTY INST
Y INSTY INST
Y INST
ALLALL
ALLALL
ALL
AA
AA
A
TT
TT
T
ION - 1984 AION - 1984 A
ION - 1984 AION - 1984 A
ION - 1984 A
ND OLDERND OLDER
ND OLDERND OLDER
ND OLDER
Important-This installation is designed for 1984 and older U.S. made Ford cars, trucks, and vans. For newer
vehicles, an installation kit may be required. See Kit Listing on Page 1 of this manual or refer to the in-store chart.
1. Remove the Existing Radio:1. Remove the Existing Radio:
1. Remove the Existing Radio:1. Remove the Existing Radio:
1. Remove the Existing Radio:
A. Remove radio knobs and shaft nuts behind the knobs.
B. Locate and remove support brace at back of radio.
C. Push radio back into dashboard to access the wiring and antenna cables plugged into the rear of the chassis
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Wire the New Radio:2. Wire the New Radio:
2. Wire the New Radio:2. Wire the New Radio:
2. Wire the New Radio:
A. In most cases it is easier to wire the radio before mounting it. Place the radio near the dashboard so the
wires can be led through the opening.
B. Carefully follow the diagram on pages 8 to wire the radio, making certain all connections are secure and
insulated with wire nuts or electrical tape to insure proper operation of the unit.
C. After completing the wiring, turn the unit on to confirm operation (ignition switch must be "on"). If unit does
not operate, re-check all wiring until problem is corrected. Once proper operation is achieved, turn off unit
and ignition switch, and proceed with final mounting of the radio.
3. Install the New Radiio:3. Install the New Radiio:
3. Install the New Radiio:3. Install the New Radiio:
3. Install the New Radiio:
A. Thread a shaft nut halfway down each radio shaft.
B. Place the nosepiece collar on the radio nosepiece.
C. Place the radio behind dashboard and through the radio opening. Adjust the position of the shaft nuts so
that the radio nosepiece and collar are flush against the back of the dashboard.
D. Secure the radio with a shaft nut on each radio shaft.
E. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or
below the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from
the weight of the radio or improper operation of the radio due to vibration.
F. Install knobs on radio shafts.
-5-
IMPORTANT
A MOUNTING KIT IS
REQUIRED
FOR THIS INSTALLATION