Filter
Top Products
© 2007 • All rights reserved. 5
Storm Series LCR Theater Speakers
3. Installation
The Installation process is divided into three distinct processes: Wiring, Mounting and Set-
ting Switches.
After carefully considering the intended application (Defi ning a Listening Area,
Stereo/Critcal Listening, Home Theater, etc.), specifi c mounting locations can be decided upon.
Once the specifi c locations are determined, installation can commence.
Wiring
Before actually running any wire or cable, take the time to look around each room or area of the
house and plan your wire paths for maximum effi ciency. Look for routes through uncluttered
parts of the stud wall or ceiling that allow you to group all low-voltage (video, speaker wires, Cat-
5, telephone, etc.) wires wherever possible. It is a good practice to label both ends of all cables
and to protect wires by tying a plastic bag over the ends.
LEFT
SPK
Plastic BagLabel
Figure 3.1: Wiring Label & Plastic Bag
Wiring Methodology
There are three common scenarios for connecting speaker to an audio system. Figure 3.2
shows a home theater wiring scheme while Figures 3.3 to 3.5 show stereo pairs.
• Five 2 conductor speaker wires run from the A/V Receiver
to each speaker.
A/V Receiver/Amplifier
Figure 3.2: Wiring: Amplifi er to Speakers - Home Theater