Filter
Top Products
12 ©2007 • All rights reserved.
Storm Series LCR Theater Speakers
Mounting Speakers in Wall (Pre-Construction or Retro-Fit)
1. Remove speaker grille and place speaker face down.
2. Locate the speaker wire and pull through the wall opening.
3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY!
4. Insert the speaker into the opening in the wall (or Rough-in Bracket opening) and care-
fully tighten each of the six clamping screws, alternating diagonally between each screw
position to ensure proper fi t.
5. Aim the pivoting tweeter at the listening area.
7. Set the Treble and Bass switches. See Setting Switches for details.
8. Replace the speaker grille.
Figure 3.13: Mounting Speaker In Wall
Setting Switches
Once the speakers are wired, mounted, and positioned correctly, use the Bass and Treble
switches to fi ne-tune the speakers based on local environmental variables such as hardwood
fl oors, thick draperies, etc. Select the “+” position to increase Bass/Treble response or select
the “-” position if no increase or decrease is desired.
BASS
BASS
TREBLE
TREBLE
Figure 3.14: Bass & Treble Switches