Instruction Manual
3
Unpacking and Assembly
Unpacking the Speakers
Use care when unpacking the speakers. Since the grilles are packed off the
speakers, be particularly careful of the driver elements as you unpack and
move the speakers. Remember to keep the original boxes and packing mate-
rial, in the unlikely event the speakers need servicing, or if you move.
Attaching the Feet
The cast aluminum feet with spikes are shipped unattached to the speaker.
We recommend you attach the feet before proceeding to any other aspect
of setup and installation.
Attach the feet to the bottom of the speaker cabinet as shown. The spikes
can be adjusted to level the speaker. Circular metal discs are provided to
protect hardwood floors.
Attaching the Grilles
The included metal grilles are held to the front of the enclosures with power-
ful neodymium magnets. There are depressions on the back of the grille that
the magnets fit into. Once the speakers are in their final position, remove
the grille from its protective plastic bag and carefully position it over the
magnets on the baffle.
Move them together slowly and when you get close enough, the magnets
will draw the grille in and hold it tight. Be careful not to get your fingers
caught between the grille and the cabinet.
Glass Tops
Decorative smoked glass tops are provided for the AT-1 to complete its
elegant appearance. Attach the four self-adhesive rubber pads to the top of
the cabinet as shown to prevent vibration and place the glass on top of the
cabinet with the bevel towards the front. (See figure 2)
Figure 2
Installing the glass top
Figure 3
AT-1 High-performance
loudspeaker
Figure 1
Attaching the feet
Screw tips into
foot. Adjust to
level speaker.
Optional tip
"toes" protect
hardwood floors.
Attach feet to
threaded inserts in
bottom of cabinet
with supplied screws.