Filter
Top Products
TriplePlay Multizone Satellite Audio Receiver 9
© 2003 Antex Electronics, Inc.
Blocking Channels
Using the Parental Control feature, you can block specific
channels so that can be accessed only with a pass code that you
define. Parents find this feature useful for preventing their
children access to specific content.
To block a channel:
1. Press and hold the POWER button to enter SETUP mode.
2. Press the CHANNEL down button to highlight “PARENTAL
CONTROL,” and then press the SELECT button. A screen
similar to that shown below appears.
XXXX
ENTER PASSWORD
SRX
-
3 TriplePlay
Press SELECT to Accept
Preset to Exit
XXXX
ENTER PASSWORD
SRX
-
3 TriplePlay
Press SELECT to Accept
Preset to Exit
“XXXX” will appear for the password. You must set a
password (if this is the first time at this menu) or enter a
previously set password to proceed. Be careful to use a
familiar number. Write this number down for future
reference.
Pass code: _________________________
3. Enter 4 digits with the numeric buttons or remote, and then
press SELECT. (To exit this menu without setting or entering
the password and return to the previous menu, press the
PRESET button.)
After you have entered the password successfully, the
following menu will appear.
CHANGE PASSWORD
BLOCK CHANNELS
RETURN
PARENTAL CONTROL
SRX
-
3 TriplePlay
CHANGE PASSWORD
BLOCK CHANNELS
RETURN
PARENTAL CONTROL
SRX
-
3 TriplePlay
Note that you can change the password by repeating steps 1
through 3.
4. Scroll to highlight “BLOCK CHANNELS”, and then press the
SELECT button. A menu similar to that shown below
appears.
70 Planet Jazz BLKd
PARENTAL CONTROL
ZONE 1
SRX
-
3 TriplePlay
Press SEL to Return
UP/DN to select Channel
LF/RT to change Status
Zone to change Zone
70 Planet Jazz BLKd
PARENTAL CONTROL
ZONE 1
SRX
-
3 TriplePlay
Press SEL to Return
UP/DN to select Channel
LF/RT to change Status
Zone to change Zone
— Use the CHANNEL up/down buttons to scroll to the
channel you want to block.
— Use the CATEGORY left/right buttons to toggle the status
between blocked “BLKd” or unblocked “NRML”.
5. Block (or unblock) as many channels as you choose. When
finished, press the SELECT button to return to the default
display.