Filter
Top Products
User and Installation Guide
Page 3
R
Step 3
Installing the headphone batteries
Two AA (UM-3, R6, Mignon - 1.5 V) batteries are required to operate the
headphones. Rechargable batteries with a sufficiently high voltage can be used
as well. Choosing batteries with a high capacity (mAh) will extend operating time.
There are two battery compartments, located on both sides, each housing one
battery. To access each battery compartment, push on the outer edge of the
battery lid. This will release the battery lid. Then lift the middle portion of the
battery lid to gain access to the battery compartment.
Insert the battery by pressing the minus pole of the battery against the spring at
the bottom of the battery compartment until the plus pole can slide into the battery
compartment. The battery should snap into place.
Be sure to only use batteries with a well formed plus pole to ensure proper
contact between the plus pole of the battery and the plus pole inside the battery
compartment and also to ensure that the battery will not slide out of the battery
compartment unintentionally.
Finally, close the battery lid by pushing the middle section. It should snap into the
closed position.
To replace the batteries, open the battery lid as described above and pull the
battery out of the battery compartment by pushing the battery towards the bottom
until the plus pole is released and slides out.
Push
123
ATTENTION!
Never leave batteries inside the headphones for very long periods
of time to prevent any damage to the headphones from leaking
batteries. Dispose of spent batteries conforming to local waste
disposal rules.
Lift