Filter
Top Products
BASIC OPERATIONS (CONT.)
American Audio® • DIGI-PRO™ INSTRUCTION MANUAL • PAGE 23
1) Be sure a disc is inserted in the drive and press the PRG/HOLD
FX (13). Pressing the PRG/HOLD FX (13) from any function will
immediately pause the disc and enter the program mode.
2) After activating the program mode the program indicator LED
beside the PRG/HOLD FX (13) and the PROGRAM INDICATOR
(52) in the LCD (14) will begin to glow indicating Program
Mode has been activated.
16. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the
order they will be played in. You may program a maximum of 20 tracks at once and program a single track to
played more than once. To create a program:
Figure 27
3) Select a track to be programmed by using
the FORWARD TRACK SKIP (21) and
BACK SKIP TRACK BUTTON (20).
4) Once you reach the track you wish to place in to the program
memory pressing PRG/HOLD FX (13) will lock the track into
memory.
Figure 29
Figure 28
5) Repeat these steps three and four up to 29 times (up to 30 tracks may be programmed).
6) As you program tracks in memory the LCD (14) will indicate the tracks that have been programmed
in to memory.
7) When you have finished your programming and are ready to begin
playback simply press the PLAY/PAUSE BUTTON (29) and your
program will begin to play.
8) After you have complete your program you can always add more
tracks to your program by repeating the steps one through four.
Remember that you can only a maximum of 30 track in a program
and you can only add track not subtract.
9) To cancel and clear the program press and hold down the PRG/
HOLD FX (13) for more than two seconds (see figure 29).
Figure 30