Filter
Top Products
BASIC OPERATIONS (CONT.)
©American Audio® - www.americandj.com - DIGI-PRO™ Instruction Manual Page 19
12. PITCH BEND:
This function will momentarily increase or decrease a tracks playback speed. There are two ways to operate
this function with the (-) & (+) PITCH BUTTONS (25) or with the JOG WHEEL (19). The maximum pitch bend
percentage allowed is +/- 16%. The pitch bend function will work in conjunction with the PITCH SLIDER
(23) pitch setting. The PITCH SLIDER (23) adjustment can be changed to range from +/-8%, +/-12%, or
+/-16% (See changing "PITCH SLIDER PERCENTAGE RANGE" on page 16). For example, if the PITCH
SLIDER (23) is set to a 2% pitch gain the pitch bending process will begin at 2% and wi
ll continue to
the maximum of -/+16%.
PITCH BEND BUTTONS (15 & 16):
The (+) PITCH BEND BUTTON (15 & 16) will provide a speed bump and the (-) PITCH BEND BUTTON (15)
will provide a slow down. The extent to which the speed changes is proportionate to the amount of time the
button is pressed. For example, if the (+) PITCH BEND BUTTON (16) is held down continuously, the disc speed
will increases and will continue to increase until reaches a maximum of 100% speed gain. When you release
the (+) PITCH BEND BUTTON (16) the disc speed will automati
cally return to it’s previous speed.
Holding down or tapping on the (+) PITCH
BEND BUTTON (16) will provide a speed
bump in the playback pitch.
Holding down or tapping on the
(-) PITCH BEND BUTTON (15)
will provide a slow down in the
playback pitch.
Figure 15
Figure 16
JOG WHEEL (19):
The JOG WHEEL (19) will temporarily bend the pitch if a track is in
play mode Rotating the wheel in a clockwise direction will increase your
track pitch and rotating the wheel in a counter-clockwise direction will
slow your track pitch. The speed you rotate the JOG WHEEL (19) will
determine pitch bend percentage (%).
Figure 17