Filter
Top Products
12
Mid Frequency Driver replacement continued:
5
5
Four screws and locking washers may
be removed from the mid frequency
driver using the phillips head screwdriver.
Contrary to what the picture shows, the
screws are actually about 2
3/4
” down
from the top of the horn assembly. Also
note that the screws may be tighter than
usual. Please DO NOT add WD-40 or any
other lubricant to help loosen the screws.
1
1
2
2
3
3
4
4
-
-
+
+
1
1
2
2
3
3
4
4
-
-
+
+
6
6
Keep the four screws and locking
washers in a safe place.
7
7
The mid frequency driver easily lifts right
off of the horn. Replace with the new
driver (part #0013897) and follow the
same steps as above, but backwards 7
to 1. Power up the SA1530z and the new
driver should now be pumping out those
mids again. Right on, you just replaced a
mid frequency driver!