Filter
Top Products
10
3
3
A closeup of the high frequency driver
is shown above. Four screws need to be
removed from the driver using the 3mm
allen wrench.
4
4
Keep the four screws in a safe place.
5
5
The diaphragm and plate adapter are
easily removed from the horn assembly.
They may not be broken down any
further. Place the new diaphragm (part
# coming soon) and plate assembly
where the old one was. Follow the same
steps as above, but backwards 4 to
1. Power up the SA1530z and the new
diaphragm should now be pumping
out those highs again. Sweet, you just
replaced a diaphragm!
Diaphragm replacement:
2
2
Follow steps 1-6 of the high frequency
driver replacement instructions, as the
horn assembly will need to be removed
in order to access the diaphragm.
1
1
At the present time (January 2007),
diaphragms are not currently available,
so you will have to replace the complete
driver following the previous section
(pages 6-9). If you have received a
diaphragm, please follow the steps
below.
1
1
2
2
3
3
4
4
-
-
+
+