Filter
Top Products
13
Outputs1~6,RS485 OUT
GROUND
HOT (+)
COLD ( )
3
2
1
BALANCED XLR-F
8. APPLICATION
#
01
02
03
04
05
06
07
08
09
10
Name
DEFAULT
2X2W+MAX
2X3W
2X3W+MSB+MAX
4W+2MAX
4W+BSB+2MAX
5W+MAX
5W+BSB+MAX
6W
6W+BSB
Configuration
A135 B246
A13 B24 S56
A135 B246
A13 B24 S56
A1324 S56
A123 B4 S56
A12345 S6
A1234 B5 S6
A123456
A12345 B6
Configuration
Default preset - routing = 3-WAY STEREO
2-WAY STEREO + 2 MONO FULL-RANGE OUT
3-WAY STEREO
3-WAY STEREO with MONO SUB + 1 MONO FULL-RANGE OUT
4-WAY MONO + 2 MONO FULL-RANGE OUT
4-WAY MONO with B-SUB + 2 MONO FULL-RANGE OUT
5-WAY MONO + 1 MONO FULL-RANGE OUT
5-WAY MONO with B-SUB + 1 MONO FULL-RANGE OUT
6-WAY MONO
6-WAY MONO with B-SUB
8.1 Factory Preset Configuration
The following diagrams show the MAXIDRIVE3.4 PC's various system configurations, as if to say, the various input
and output hardware combinations.
RS232
RS232 (9Pin-F)
PIN 5 PIN 3 PIN 2
(RXD) PIN3
(GND) PIN5
(TXD) PIN2 PIN 3(RXD)
PIN 2(TXD)
PIN 5(GND)
The wire must be changed between 2,3 pin.
9 PIN
9 PIN
Special attentions for R 232 interface:S
1. Be careful not to use the pin-to-pin cable in the system, it may damage the communication part of this unit.
2. Be sure to use the female connector on both sides of the cable.
3. The length of this cable must not exceed 30 meters, or there would be some unexpected communication errors.
4. If you want to use a long distance remote control, it would be better to use shielding wire for this cable.