Filter
Top Products
MULTI-TASKER
10
14. [G]
This command is used to request group data.
With the command, the user can identify which
input or output of a particular group is on.
Command Format: [GkUi]
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
If group 1 has DA Cards with outputs 1 and 2
on, while group 2 has SW Cards with input 2 on:
[G1]: will return feedback as ON12 G1U0.
[G2]: will return feedback as ON2 G2U0.
15. [RD]
This command displays the members in each
group. Members can be any card in enclosure
slots 1 to 19.
Command Format: [RDGkUi]
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
To read member data for group 1 of unit 1, send
the [RD] command. The system will return
feedback as C1C2C3 G5U1.
7.3 SUMMARY OF COMMANDS
1) [VER] Receives software version
2) [C] Receives status of the card
3) [CiS] Save card configuration
4) [SIGCi] Check for input signal
5) [ON] Turns on one or more outputs for
a single card or a group of cards
6) [OFF] Turns off one or more outputs for
a single card or a group of cards
7) […S] Save the command configuration
8) […F] Provides feedback upon sending
9) […P] Sets the path, preload for [SW]
10) [SW] Switch, preloaded outputs
11) [HELP] Display available commands
12) [WR] Groups multiple cards
13) [CLR] Clears members of a single
group or all groups
14) [G] Requests group data
15) [RD] Displays group members