Filter
Top Products
MULTI-TASKER
9
Example:
If 2 cards are in slots 6 and 7 of unit 3:
To disable outputs 1 and 2 of card 6 and
outputs 3 and 4 of card 7 simultaneously, use
the following commands:
[OFF12C6U3P]
[OFF34C7U3P]
[SW]
If "F" is included use the [OFFmCnUiPF]
command or the [OFFmCnUiFP] command.
[OFF…..F]: feedback
After processing a command, an OK ER will be
returned as feedback if "F" is included at the
end of a command string.
Example:
[OFF1C2U3F]: if path is not set
[OFF1C2U3PF]: if path is set
7. […S] – Save
This command will save the configuration
command being sent in memory. When
sending the command [ON1C4S], after reset or
power up, output 1 on C4 will be enabled.
8. […F] – Feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
9. […P] – Path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
loaded. See examples in ON and OFF
commands.
10. [SW] – Switch
The switch command immediately connects
inputs and outputs, which were previously set
with the PATH command on this card and all
other cards in the MT100-100.
11. [HELP]
This command displays all information available
for user Multi-Tasker interface commands.
Command Format: [HELPCnUi]
Cn = card ID number (n = # from 1 to 19)
Ui = Unit ID (i = # from 0 to 9) (refer to the
MT100-100 user’s guide for explanation)
Example:
In order to view the RS-232 commands
available for the MT108-103 card in slot 2 of
unit 3, send the command [HELPC2U3]. The
commands along with a brief description will be
displayed in the Terminal Window.
12. [WR]
This command groups multiple cards in the
MT100-100 Enclosure. Each unit contains a
maximum of nine groups.
Command Format: [WRCn…GkUi]
n = card ID No. (n = slot # from 1 to 19)
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
To group cards #1, 2, and 3 as group 5 of unit
#1, send the command [WRC1C2C3G5U1].
After executing this command, cards 1, 2, and 3
of unit 1 will be grouped together as group 5.
13. [CLR]
This command clears the members for a single
group or for all nine groups.
Command Format: [CLRGkUi]
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
a) To clear group #1, send the [CLRG1U1]
command. This command clears the
members for the specified group only.
b) To clear all groups of unit 1, send the
[CLRG[U1] command.