Filter
Top Products
13-EN
01GB04CDE9874E.fm
ALPINE CDE-9874E 68-09359Z38-A (EN)
*
1
The adjustment can also be made by pressing Rotary encoder
(CDE-9874E only) or /AUDIO (CDE-9872E only). Refer to
“Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Loudness/Defeat” (page 12).
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
-1 Press and hold SOUND for at least 2 seconds to
activate the Sound Setting mode (CDE-9872E only).
1
-2 Press SOUND/SETUP (CDE-9874E only) or
SOUND (CDE-9872E only) repeatedly to select the
TREBLE mode.
BASS TREBLE HPF BASS
2
-1 Press BAND to select the desired treble centre
frequency.
10.0 kHz 12.5 kHz 15.0 kHz 17.5 kHz 10.0 kHz
Emphasizes the displayed treble frequency ranges.
2
-2*
2
Turn the Rotary encoder (CDE-9874E only) or
press and (CDE-9872E only) to select the
desired treble level (–7~+7).
You can emphasize the treble level.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
• The function is inoperable when DEFEAT is set to ON.
*
2
The adjustment can also be made by pressing Rotary encoder
(CDE-9874E only) or /AUDIO (CDE-9872E only). Refer to
“Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Loudness/Defeat” (page 12).
Adjusting the High Pass Filter
The High Pass Filter on this unit can be adjusted to suit your personal
taste.
1
-1 Press and hold SOUND for at least 2 seconds to
activate the Sound Setting mode (CDE-9872E only).
1
-2 Press SOUND/SETUP (CDE-9874E only) or
SOUND (CDE-9872E only) repeatedly to select the
HPF mode.
BASS TREBLE HPF BASS
2
Turn the Rotary encoder (CDE-9874E only) or
press and (CDE-9872E only) to select the
desired HPF frequency.
OFF 80 Hz 120 Hz 160 Hz
All frequencies above the selected cutoff are output.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The function is inoperable when DEFEAT is set to ON.
Setting the Treble Centre Frequency
Setting the Treble Level
68-09359Z38-A_F.book Page 13 Tuesday, September 4, 2007 4:15 PM