Filter
Top Products
10-EN
Installation and
Connections
Installation
Caution
Do not block the unit’s air vents. This unit requires
adequate air circulation. If blocked, heat will accumulate
inside the unit and may cause a fire.
Accessory List
• XM data receiver .......................................................... 1
• Power cable.................................................................. 1
• Navigation connection cable (5m) ............................... 1
• XM tuner cable (3m)..................................................... 1
• Self tapping screw (M4 × 14) ....................................... 4
• Velcro Fasteners .......................................................... 2
• An antenna is required for the proper operation of this
receiver. This antenna must be purchased separately.
Please follow the installation instructions supplied with the
antenna.
Velcro fastener Mounting
When mounting the unit with the Velcro fasteners, be sure to
choose a flat location.
Do not hang the unit from the bottom of the dashboard or rear
deck with the Velcro fasteners.
1
Remove the protective paper and attach two
pieces of velcro fastener to the bottom of the
unit.
2
Check the position, and then fix the unit to
the floor carpet.
Screw-down Mounting
When mounting the tuner with the screws, be sure to choose a
flat location.
1
Using the unit as a template, hold it at its
mounting location and mark the holes to be
drilled. Before drilling, make sure that there
are no objects that could be damaged behind
the mounting surface.
2
Drill holes and secure the unit with self-
tapping screws (M4 x 14) supplied.
Velcro Fasteners
(Included)
Protective paper
Air vents
(Side of the unit)