Filter
Top Products
12-EN
Sound Setting
CDE-9845
CDE-9843
CDE-9841
Adjusting Bass/Treble/Balance (Between Left
and Right)/Fader (Between Front and Rear)/
Defeat
1
Press the Rotary encoder (CDE-9845/CDE-9843
only) or press MODE (CDE-9841 only) repeatedly
to choose the desired mode.
Each press changes the modes as follows:
BASS → TREBLE → SUBWOOFER* → BALANCE → FADER
→ DEFEAT → VOLUME → BASS
BASS: -7 ~ +10
TREBLE: -7 ~ +7
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
• If the Rotary encoder is not pressed within 5 seconds after
selecting the BASS, TREBLE BALANCE, FADER, DEFEAT or
SUBWOOFER mode, the unit automatically returns to normal
mode.
* When the subwoofer mode is set to OFF, its level cannot be
adjusted.
2
Turn the Rotary encoder (CDE-9845/CDE-9843
only) or press
44
44
4 and
33
33
3 (CDE-9841 only) until the
desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of
BASS and TREBLE will return to the factory defaults and
BBE* is turned off.
* CDE-9845 only
Setting the Bass Control
You can change the bass frequency emphasis to create your own tonal
preference.
1
Press BASS C. (CDE-9845/CDE-9843 only) or
press CENTER f. (CDE-9841 only) to select the
Bass (bass center frequency) Control mode.
CDE-9845/CDE-9843:
BASS ↔ normal
CDE-9841:
BASS → TREBLE → normal mode → BASS
2-1
Setting the bass center frequency:
Press g or f to select the desired bass center
frequency.
60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔ 60Hz
The displayed bass frequency is emphasized
2-2
Setting the bass band width (Q-Factor):
Press BAND to select the desired bass band
width.
Changes the boosted bass band width to wide or narrow.
A wide setting will boost a wide range of frequencies
above and below the center frequency. A narrower setting
will boost only frequencies near the center frequency.
2-3
Setting the bass level:
Turn the Rotary encoder (CDE-9845/CDE-9843
only) or press
44
44
4 and
33
33
3 (CDE-9841 only) to select
the desired bass level (–7~+10).
You can emphasize or weaken the bass frequency.
• If no operation is performed within 15 seconds, the bass control
setting will be turned off automatically.
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass band width settings adjusted for one source are
effective for all other sources (FM, AM, CD etc.).
• This function is inoperable when DEFEAT is set to ON.
SOURCE/
POWER
BAND
g f
Rotary encoder
SOURCE/
POWER BAND
g f
Rotary encoder
SOURCE/
POWER
BAND
g f
BASS C. TREBLE C.
BASS C. TREBLE C.
CENTER f. MODE
4
3
......................................
→ 1 → 2 → 3 → 4
(Narrow)←→(Wide)