Filter
Top Products
24-EN
Time Difference Table
0 0.0 14 1.4 28 2.8
1 0.1 15 1.5 29 2.9
2 0.2 16 1.6 30 3.0
3 0.3 17 1.7 31 3.1
4 0.4 18 1.8 32 3.2
5 0.5 19 1.9 33 3.3
6 0.6 20 2.0 34 3.4
7 0.7 21 2.1 35 3.5
8 0.8 22 2.2 36 3.6
9 0.9 23 2.3 37 3.7
10 1.0 24 2.4 38 3.8
11 1.1 25 2.5 39 3.9
12 1.2 26 2.6 40 - 98 4.0 - 9.8
13 1.3 27 2.7 99 9.9
Number of
Steps
Time
Difference
(ms)
Number of
Steps
Time
Difference
(ms)
Number of
Steps
Time
Difference
(ms)
5
Repeat Step 4 and set another speaker.
6
When finished with the settings, press / or -,
select EXIT, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
• Selection of CONTINUE will cause a return to the time
correction adjustment mode.
• Selection of P-MEMORY will set the storage mode of the
adjustment value. (See “Storing the Adjustment
Contents”.)
7
Press AUDIO TUNE to return to the normal mode.
• The adjustment value in the time correction adjustment is also
reflected in the Bass Focus mode.
Storing the Adjustment Contents
1
Following Step 6 mentioned on the left within 15
seconds, press / or - to select P-MEMORY, then
press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
2
Press / or - within 15 seconds, select one of
“PRESET 1” to “PRESET 6,” and press -/J / ENT..
This will store the adjusted contents in the selected
PRESET number.
3
Press AUDIO TUNE to return to the normal mode.
• The contents stored in presets 1 to 6 will be maintained even when
the unit is reset or the battery power cable is disconnected.
Calling the Stored Time Correction Value
1
Following Step 3 mentioned on the left, press / or
-, select the SELECT mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
2
Press / or - within 15 seconds, select one of
“PRESET 1” to “PRESET 6,” and press -/J / ENT..
This will call the stored adjustment contents.
Time Correction Adjustment and Storage/
Calling
Before performing the following procedures, refer to “About the Time
Correction” (page 22).
1
Press AUDIO TUNE.
2
Press / or - within 15 seconds, select the time
correction adjustment mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
3
Press / or - within 15 seconds, select the
ADJUST mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
4
Press / or - within 15 seconds to adjust the time
correction value (0.0 to 9.9) of the first speaker
(F-L), then press -/J / ENT. to set.
B-FOCUS
(BSF)
EQ LPF
T-CORR
(TCR)
HPF
F-L F-R R-L R-R