Filter
Top Products
21-EN
Recalling the Equalizer Curve
1
Press AUDIO TUNE.
2
Press / or - within 15 seconds, select the EQ
mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
3
Press / or - within 15 seconds, select the
SELECT mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
4
Press / or - within 15 seconds, select the desired
equalizer characteristics, and press -/J / ENT. to
set.
The mode that is blinking at the centre of the display is the
selected mode.
5
Press AUDIO TUNE to return to the normal mode.
Adjusting and Storing the Equalizer Curve
1
Press AUDIO TUNE.
2
Press / or - within 15 seconds, select the EQ
mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
3
Press / or - within 15 seconds, select the
ADJUST mode, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
4
Press / or - within 15 seconds to adjust the LOW
level (1 to 9)*, then press -/J / ENT. to set.
5
Repeat Step 4 to set another band.
6
When finished with the settings, press / or -,
select EXIT, and press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
• Selection of CONTINUE will cause a return to the
ADJUST mode.
• Selection of P-MEMORY will set the storage mode of the
adjustment values.
(See “Storing Adjustment Contents”)
7
Press AUDIO TUNE to return to the normal mode.
• This function is inoperable when DEFEAT is ON (See Page 5).
•Please give consideration to the frequency response of the
connected speakers when making adjustments.
* The level can be adjusted to ±12dB with 3dB steps.
“Level 9: +12dB” “Level 7: +6dB” “Level 5:
0dB (FLAT)” “Level 3: –6dB” “Level 1:
–12dB”
Storing Adjustment Contents
1
Following above-mentioned Step 6 within 15
seconds, press / or - to select P-MEMORY, then
press -/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
2
Press / or - within 15 seconds, select one of
“PRESET 1” to “PRESET 3”, and press -/J / ENT..
This will store the adjusted contents in the selected
PRESET number.
3
Press AUDIO TUNE to return to the normal mode.
• The contents stored in presets 1 to 3 will be maintained even when
the unit is reset or the battery power cable is disconnected.
• The stored contents can be called using the “Recalling the
Equalizer Curve” operation.
Flat frequency
Suppress midrange
Emphasize lows and highs
Boost midrange and suppress highs
and lows
Calls the adjustment values stored in
the PRESET number.
B-FOCUS
(BSF)
EQ LPF
T-CORR
(TCR)
HPF
FLAT(OFF)
POPS
ROCK
NEWS
P-1~P-3
B-FOCUS
(BSF)
EQ LPF
T-CORR
(TCR)
HPF
LOW MID-LOW MID-HIGH
HIGH
(60Hz) (150Hz) (2.5kHz)
(10kHz)